{"product_id":"fire-lite-znac-ps-class-output-converter-mod-ps-series-power-supply","title":"Fire-Lite ZNAC-PS Class Output Converter MOD-PS Series Power Supply","description":"The PS Series is a remote power supply line from FireLite Alarms and is a direct replacement for the FCPS-24FS6\/8 Series. The FLPS6(C) is a 6 amp and the FL-PS10(C) is a 10 amp, remote power supply with battery charger that may be connected to any 12 or 24 volt fire alarm control panel (FACP) or used as a standalone power supply.\n\nThe PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as either Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options.\n\nThe PS Series also provides auxiliary power, constant or resettable, suited for detectors, annunciators, door holders, and other fire alarm system peripherals. The PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH batteries in a separate cabinet.\n\u003ch4\u003e\u003cb\u003eFeatures\u003c\/b\u003e\u003c\/h4\u003e\n\u003cul\u003e\n  \u003cli\u003eUp to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:\u003c\/li\u003e\n  \u003cli\u003eClass B and\/or Class A NACs\u003c\/li\u003e\n  \u003cli\u003eClass B and\/or Class A resettable or non-resettable 24V auxiliary power\u003c\/li\u003e\n  \u003cli\u003edoor holder power\u003c\/li\u003e\n  \u003cli\u003eConverts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately)\u003c\/li\u003e\n  \u003cli\u003eOptimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power\u003c\/li\u003e\n  \u003cli\u003eConfigurable for ANSI® Temporal 3 or Temporal 4 coded output\u003c\/li\u003e\n  \u003cli\u003eUL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances\u003c\/li\u003e\n  \u003cli\u003eSynchronization can be triggered from FACP NAC\/remote sync outputs, cascaded power supply, or a control module, single or multi, which may be housed within the power supply cabinet\u003c\/li\u003e\n  \u003cli\u003eAbility to cascade up to four power supplies\u003c\/li\u003e\n  \u003cli\u003eTwo (6 amp model) or three (10 amp model) fully-isolated input\/ control circuits which can be programmed to any output\u003c\/li\u003e\n  \u003cli\u003eTwo Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only\u003c\/li\u003e\n  \u003cli\u003e6 or 10 amp full load output, respectively, with 3 A maximum\/circuit\u003c\/li\u003e\n  \u003cli\u003eIndividual NAC power and trouble LEDs for diagnostic efficiency\u003c\/li\u003e\n  \u003cli\u003eTrouble history modes for diagnostic support\u003c\/li\u003e\n  \u003cli\u003eWide range end-of-line supervision value (normal: 2K-27K ohms)\u003c\/li\u003e\n  \u003cli\u003eSelectable earth fault detection (enable or disable)\u003c\/li\u003e\n  \u003cli\u003eAC trouble report delay timer\u003c\/li\u003e\n  \u003cli\u003eCompletely configurable via onboard DIP switches, no extra software required\u003c\/li\u003e\n  \u003cli\u003eSelf-contained in compact, locking cabinet constructed of heavy gauge steel with a corrosion-resistant powder coat chip and scratch-resistant finish\u003c\/li\u003e\n  \u003cli\u003eCabinet designed with ten double knockouts and a removable door for ease of installation and wiring\u003c\/li\u003e\n  \u003cli\u003eIncludes integral battery charger capable of charging up to 33 AH batteries\u003c\/li\u003e\n  \u003cli\u003eCabinet can house two 7 AH or 18 AH batteries\u003c\/li\u003e\n  \u003cli\u003eBattery charger may be disabled via DIP switch for applications requiring larger batteries and external battery charger\u003c\/li\u003e\n  \u003cli\u003eRemovable terminal blocks accommodate up to 12 AWG (3.1mm2) wire\u003c\/li\u003e\n  \u003cli\u003eWorks with any UL 864 FACP which utilizes an industry-standard reverse-polarity notification circuit\u003c\/li\u003e\n  \u003cli\u003eOptional devices include addressable control, monitor, and relay modules and power-supervision relay (EOLR-1)\u003c\/li\u003e\n  \u003cli style=\"list-style-type: none;\"\u003e\n\u003cul\u003e\n  \u003cli style=\"list-style-type: none;\"\u003e\n\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003c\/li\u003e\n\u003c\/ul\u003e","brand":"Fire-lite Alarms By Honeywell","offers":[{"title":"Default Title","offer_id":43247307653185,"sku":"FL-ZNACPS","price":159.23,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0700\/2465\/9009\/files\/08cf4c2a-fl-znacps_lg.jpg?v=1770770339","url":"https:\/\/www.fireandsafetyplus.com\/products\/fire-lite-znac-ps-class-output-converter-mod-ps-series-power-supply","provider":"Fire and Safety Plus","version":"1.0","type":"link"}