Showing 17–32 of 103 results
$ 551.53In stock
Power supply’s advanced switch mode design reduces damaging heat and manages power up to 50% more efficiently than other systems
Built-in synchronization for appliances from AMSECO, Gentex®, Faraday, System Sensor® and Wheelock®
Four regulated and power-limited notification outputs with support of up to two Class A circuit wiring
$ 784.93In stock
6A output power
Six Flexput™ circuits rated at 3A each can be programmed as notification appliance circuits, auxiliary power, or initiation circuits
Supports Class A configuration for SBUS and Flexput™ circuits
Each output individually mapped through fire alarm control panel programming
Two form C programmable relays rated at 2.5A at 24VDC
$ 562.06In stock
Low Profile
$ 729.09Guaranteed In Stock!
Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:
Class B and/or Class A NACs
Class B and/or Class A resettable or non-resettable 24V auxiliary power
door holder power
Sale!
$ 474.75Original price was: $474.75. $ 280.00Current price is: $280.00. Only 19 left in stock (can be backordered)
6-Amp model includes 5 ouputs and 2 inputs (Class A or Class B)
Includes fully configurable inputs that can be paired with any output
$ 338.71Only 1 left in stock
Up to five (6 amp model) or seven (10 amp model) independently-configurable, powerlimited output circuits for:
Class B and/or Class A NACs
Class B and/or Class A resettable or nonresettable 24V auxiliary power -door holder power
Converts from Class B to Class A wiring without losing any outputs using the ZNACPS converter card (sold separately)
Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power
$ 26.21In stock
Depth
Form Factor
$ 111.07In stock
TG-PEM accessory
Mounting bracket with 3 screws
Data cable
Quick Install Guide
$ 467.68In stock
PSN-106 has 10 amps regulated with 6 outputs
Configure as up to three class “A” Style “Z” notification circuits
Two Trouble relays (5A at 30VDC) General System Trouble (programmable for AC delay) Low AC Trouble with optional delay settings
Diagnostic LED’s Status LED’s for Active NAC and NAC Trouble conditions.
$ 94.88In stock
Two-wire operation from module to the devices
Silences horns and chimes over a two-wire loop
Synchronizes strobes at 1 Hz
$ 103.49In stock
Two sets of Form C contacts
Rotary address switches for fast installation
Relay programming is completely flexible – can be mapped to zone conditions
$ 101.78In stock
15 to 32 VDC
Built-in type identification automatically identifies these devices to the control panel.
Internal circuitry and relay powered directly by two-wire SLC loop
$ 408.41In stock
2-wire horn/strobe Sync mode allows audible notification appliances (horns) and visual notification appliances (strobes) to be silenced/deactivated at the same time.
Sync protocols include Potter/Amseco, Gentex®, System Sensor®, and CooperWheelock®.
Temporal Code 3, Steady Mode, Input to Output Follower Mode (maintains synchronization of notification appliances circuit).
$ 130.24In stock
Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:
Class B and/or Class A NACs
Class B and/or Class A resettable or non-resettable 24V auxiliary power
$ 22.02In stock
Can be used to activate auxiliary warning devices such as external bells and sirens, hallway or stairway lighting
This relay will only activate when it receives a smoke signal from an interconnect Smoke Alarm
Switches connected device power when a smoke/heat interconnect signal is received
$ 26.44In stock
Kidde EOL-4.7 End of Line Resistor, 4.7K Assembly, UL Approved
